Internal Data Search by Company/Division Name
Industrial MACT Webinar - Hot Topic Hour November 18, 2010 - Part 1
Sodium Bicarbonate, Lime, CDS and Regulations were among the Topics covered on the First Day of the Industrial MACT Webinar. In 60 days or so we will know the specific changes for the final Industrial MACT. Correction-- we will know what is final until it is changed again. Unfortunately it will be three more years to find out if litigants are successful in causing changes. However, it will take three years to install the equipment and run it long enough to make sure of compliance. So it would seem there are two choices. Litigate and gamble you won’t have to shut down your plant or go ahead with the assumption that the rule will stand. Password: hth107
Revision Date: 11/18/2010
Tags: Babcock & Wilcox Power Generation Group, Trinity Consultants, Lhoist / Chemical Lime, Troutman Sanders, Solvay Chemicals, Graymont, MACT, Industrial Boiler
Multi-Emissions Control - Webinar - Hot Topic Hour October 27, 2011
Speakers discussed the technology and equipment available or under development that provides multi-emissions control and can be implemented by EGU operators to achieve compliance with CSAPR and MACT limits.
Revision Date: 10/27/2011
Tags: 221112 - Fossil Fuel 化石燃料, Alstom Power, United Conveyor, Solvay Chemicals, Spray Dryer Absorber, Reagent, Chemical Injection, Dry Sorbent Injection, Spray Tower, FGD, SCR, Sodium Bicarbonate, Trona, Circulating Dry Scrubber, Direct Injection System, Air Quality, SO2, SO3, HCl, Mercury
Dr. Yougen Kong, P.E., Technical Development Manager at Solvay Chemicals, Inc., discussed dry injection of Trona or sodium bicarbonate, a low-cost solution to meet the SO2 and HCl limits in CSAPR, Utility MACT and Boiler MACT. Both Trona and Sodium bicarbonate are effective in reducing SO2 and HCl. Trona is slower to react and therefore less effective on SO2 but possibly better if all you want is HCl removal. Lots of the bicarbonate will be tied up in SO2 removal. So if you want to just remove HCl Trona may be the answer.
Revision Date: 10/27/2011
Tags: 221112 - Fossil Fuel 化石燃料, Solvay Chemicals, Reagent, Trona, Sodium Bicarbonate, Direct Injection System, Air Quality, SO2, SO3, HCl, Mercury
Biography of Yougen Kong - Solvay Chemicals - Hot Topic Hour October 27, 2011
BIO
Revision Date: 10/27/2011
Tags: 221112 - Fossil Fuel 化石燃料, Solvay Chemicals, Direct Injection System, Reagent, Sodium Bicarbonate, Trona, Air Quality, SO2, SO3, HCl, Mercury
Yougen Kong, P.E., Ph.D., Technical Development Manager at Solvay Chemicals, Inc., explained that trona can achieve up to 98 percent HCl removal while sodium bicarbonate can achieve over 99 percent while also achieving better than 90 percent SO2 removal. There is a modest price penalty for the sodium bicarbonate. On the other hand, injection avoids major capital cost and is effective over a range of 275°F to 1500°F. Bicarbonate is being used at many waste incinerators in Europe and coal-fired power plants in the US.
Revision Date: 11/18/2010
Tags: 221112 - Fossil Fuel 化石燃料, Solvay Chemicals, Sodium Bicarbonate, Trona, MACT, Industrial Boiler
Improving ESP Performance Webinar - Hot Topic Hour January 20, 2010
ESP Performance Improvement can be Substantial - Hot Topic Conclusion on January 20 There has been lots of focus on replacing ESPs with baghouses to meet upcoming regulations. The speakers in the Hot Topic Hour yesterday said there is an alternative. You can upgrade existing ESPs and achieve results which may satisfy future requirements. Dr. Yougen Kong, P.E., Technical Development Manager at Solvay Chemicals, Inc., told the attendees that “there is a better alternative to SO3 for conditioning electrostatic precipitators.” Trona addition system is simple and its capital cost is much lower than that of a SO3 production and injection system. Trona is relatively inexpensive and can be injected in several places. Mick Chambers, Southern Environmental, Inc, said that you can upgrade your ESP and with halogen-based additives in the coal, you can meet the particulate and mercury regulations. He showed that the SCA of recent installations has been relatively low and yet the performance high. So the footprint of a retrofit does not have to be large. When asked about the wet ESP using a fabric for the collection plate, Mick said that it is a good option and successful on industrial boilers and process applications. We were sorry to learn that John Caine passed away in a tractor accident last September. John had represented SEI in several of our previous Hot Topic Hours and has long been a contributor to the industry. Steve Jaasund, Manager Geoenergy Division A. H. Lundberg Associates, made a case for adding a wet ESP after the FGD system to meet the upcoming MACT regulations. In the discussion period it was speculated that the new mass monitoring requirements would make it more difficult for dry ESPs to meet emission limits. The wet ESP will eliminate the exceedance spikes associated with a stand-alone dry ESP. Paul Leanza of Pollution Control Services, Inc. indicated that many utilities have the opportunity to greatly improve performance of their existing precipitators. He indicated that 50 percent of the emissions occur during rapping (rapping reentrainment). These particles are relatively large and do not cause opacity spikes proportional to the mass increase. It was speculated that with mass monitoring this phenomenon will be an unpleasant surprise. Emissions will be higher with mass monitors than they were thought to be with opacity monitors and periodic stack testing. Ron Landreth of Albemarle was pleased to find that their brominated PAC actually improves precipitator performance whereas the non-brominated PAC may add to emissions. So it is worth considering brominated PAC to capture mercury and reduce particulate. Jean Bustard of ADA-ES (ADA Environmental Solutions LLC) related experience with a proprietary conditioning chemical which has performed well and does not impact mercury capture with PAC. The company offers another approach to conditioning hot side precipitators.
Revision Date: 1/20/2011
Tags: 221112 - Fossil Fuel 化石燃料, A.H. Lundberg Associates, Southern Environmental, Pollution Control Services, Albemarle, ADA-ES, Solvay Chemicals, Dry Sorbent Injection, Electrostatic Precipitator, Mercury
A better alternative to SO3 for conditioning electrostatic precipitators. The trona addition system is simple and its capital cost is much lower than that of a SO3 production and injection system.
Revision Date: 1/20/2011
Tags: 221112 - Fossil Fuel 化石燃料, Solvay Chemicals, Dry Sorbent Injection, Mercury
SO3 Measurement and Control - Webinar - Hot Topic Hour March 8, 2012
The affect of SO3 in the flue gas stream, emissions from the stack, particulate emissons and removal of mercury from the flue gas with ACI.
Revision Date: 3/8/2012
Tags: 221112 - Fossil Fuel 化石燃料, URS Corp., Industrial Monitor and Control Corp, Solvay Chemicals, Thermo Fisher Scientific, Lhoist, Direct Injection System, Sodium Bisulfate, Trona, SO3 Monitoring, Sodium Bicarbonate, SO3, HCl, Mercury, SO2, Monitoring
Yougen discussed the interactions between SO3, HCl, HBr, PM and Trona in flue gas.
Revision Date: 3/8/2012
Tags: 221112 - Fossil Fuel 化石燃料, Solvay Chemicals, Direct Injection System, Sodium Bicarbonate, Trona, HCl, Mercury, SO2, SO3
The speakers addressed the use of dry sorbent injection to meet the new MATS and CSAPR as well as material handling issues and methods to improve the performance of and reduce the usage of sorbents.
Revision Date: 6/21/2012
Tags: 221112 - Fossil Fuel 化石燃料, Mississippi Lime, Solvay Chemicals, Southern Air Solutions, Babcock Power, Graymont, Fabric Filter, Dry Sorbent Injection, Lime, Trona, Sodium Bicarbonate, SCR, Electrostatic Precipitator, SO2, Ammonia, Mercury, HCl, SO3, Reagent Preparation, Mixing, Milling
The effect of milling sodium sorbents on their performance in removing HCl and SO2.
Revision Date: 6/21/2012
Tags: 221112 - Fossil Fuel 化石燃料, Solvay Chemicals, Sodium Bicarbonate, Lime, Dry Sorbent Injection, Trona, SO3, SO2, Mercury, HCl, Reagent Preparation, Milling
SOLVAir Solutions by Michael Wood, Solvay Chemicals - Hot Topic Hour July 18, 2013
Discussed the use of trona and sodium bicarbonate for HCl control.
Revision Date: 7/18/2013
Tags: 221112 - Fossil Fuel 化石燃料, Solvay Chemicals, Trona, Sodium Bicarbonate, Dry Sorbent Injection, Reagent, Air Quality, HCl, Mercury, SO2, SO3
Measurement and Control of HCl - Webinar Recording - Hot Topic Hour July 18, 2013
Revision Date: 7/18/2013
Tags: 221112 - Fossil Fuel 化石燃料, SICK MAIHAK, Solvay Chemicals, United Conveyor, NatronX Technologies, Mississippi Lime, Sodium Bicarbonate, Trona, Lime, NDIR, FTIR, TDL-IR, Dry Sorbent Injection, Reagent, HCl, MATS, Air Quality, Mercury, SO2, SO3
Direct Sorbent Injection Webinar - Hot Topic Hour July 10, 2014
The Hot Topic Hour covered direct sorbent injection. It was a collaborative discussion based on information posted on the free website: Dry Scrubbing - Continuous Analysis
Revision Date: 7/10/2014
Tags: 221112 - Fossil Fuel 化石燃料, Midwest Energy Emissions Corp, P. Farber & Associates, LLC, Solvay Chemicals, Licata Energy, Dry Sorbent Injection